Simple Audio Channel Circuit Diagram for FM Transmitter

Sponsored Links


The herein circuit diagram shows a simple audio channel that can be used in an FM Transmitter. It is designed to create a clipped and filtered modulating voltage which will give the FM signal more apparent volume at the receiver.

FM transmitter circuit project DIY

A simple filter to restore the audio waveform to a sinewave shape were performed by C1, C2, and R2. The R1 sets the amount of clipping of the amplified audio  from microphone (by Q1) and which is passed to ‘the speech clipper’ performed by D1 and D2 since it will make distortion if the clipped audio were applied directly to the modulator. Q2 is added for transmitting modulation and R3 determine the frequency swing of the transmitter signal.

You may then observe the changes in wave shape as the signal passes and note the changes in audio signal amplitudo in this Simple Audio Channel Circuit Diagram for FM Transmitter (source: arrl.org).

Tags: ,

| More



This entry was posted on Monday, January 25th, 2010 at 5:25 pm and is filed under Audio. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Related:

  • 27MHz Transmitter-Receiver Radio Control PCBs and Schematic Diagram
    This article provides information about 27 MHz Transmitter-Receiver Radio Control related to its PCB assembly/construction. The picture below shows th...
  • Extends Home Entertainments via FM Transmitter Circuit Diagram
    A single-chip, short-range FM radio transmitter circuit diagram is shown in the picture below. You may extend link for your home entertainment system ...
  • SA58631 Audio Amplifier Block Diagram Schematic
    SA58631 is single-channel audio amplifier which generates a power output of 3 W with an 8-Ω load using a 9V supply. The herein schematic appears...
  • Narrow Band Transmitter and Receiver UHF Radio Modules Datasheet
    This is a miniature module of Narrow Band Transmitter and Receiver UHF Radio which is used to be applied in vehicle telemetry systems, wireless networ...
  • Under The Surface, All Modern Audio Systems are The Same
    In today’s marketplace for audio equipment, designers are challenged to satisfy very demanding consumers who expect high quality, multifunction ...

    • « High Power Broadband Antenna Switch Circuit Design

    How to Perform DS3904 Digital DIP Switch Resistor into High-Impedance Mode Circuit »

    Search terms:

    transmitter 27mhz schematic narrowband, 8 channel audio transceiver circuit, fm transmission through audio channel, show me circuit diagram of audio transmitter and receiver, 8 channel transmitter receiver full circuit description, picture of a fm transmitter project, simple audio transmitter schematic, multi, transformer, high range fm transmitter circuit



    One Response to “Simple Audio Channel Circuit Diagram for FM Transmitter”

    1. Alissa Valentin says:
      February 3, 2010 at 10:55 pm

      thank you very much for the effort you set into sharing it with me. nice blog

    Leave a Reply