Design LED Lighting 350W Power Supply using CM6900+CM6807

Sponsored Links


If you want to design a complete, efficient, standby power, and constant voltage LED lighting power supply you mayLED lighting 350W Power Supply Block Diagram using CM6900 CM6807 read the following article. Champion Microelectronic combines CM6900 resonant controller and CM6805/07 PFC series to give you that purpose. And below is the figure of LED lighting 350W Power Supply Block Diagram (click to enlarge).

In the article you will find sections discuss more detail on this LED lighting applications. It will describe you with the LED 350W Lighting System Specification for both with and without standy applications. Also there are circuit diagrams such DC/DC power supply for LED lighting (half bridge efficiency of DC/DC), PFC+Auxpower circuit, and how to apply a constant current mode in this application.

Since the applications provide a high efficiency, it can provide stable power source and cut down the maintenance cost. See completely about Design LED Lighting 350W Power Supply using  CM6900+CM6807 in this Power Supply article (source: champion-micro.com)

Tags: , , , ,

| More

Sponsored Links



This entry was posted on Wednesday, September 2nd, 2009 at 9:47 am and is filed under Power Supply. You can follow any responses to this entry through the RSS 2.0 feed. You can skip to the end and leave a response. Pinging is currently not allowed.

Related:

  • HB LED Driver, Review of Topologies and Recommendation for Automotive Lighting
    According to one article i've found, it may be predictable that growth of the high-brightness LED (HB LED) market in the next few years will be drive...
  • Light Controller Circuit Diagram using HT2040A IC
    This schematic Light Controller Circuit using a low cost, low power CMOS LSI chip - HT204oA which provides 4 SCR outputs to control the lamps that can...
  • AT9933 Datasheet and Design for a Boost-Buck Converter Circuit
    AT9933 variable frequency PWM controller IC used to be applied on automotive LED lighting to control lamp driver using a low noise boost buck topolog...
  • Design Boost-Buck Converter using HV9930
    If you consider in designing a LED lamp driver using a low noise boost buck topology to control the application, you may use the HV9930 from Supertex....
  • Selecting Proper and Suitable Integrated Circuits in Power-Supply Design
    If you stuck on your options in selecting the proper and suitable integrated circuit (IC) for a power supply applications, this article maybe you loo...

    • « Design Boost-Buck Converter using HV9930

    Connecting iPod to the Denon ASD-1R with System Connector Terminal »

    Search terms:

    cm6900, mc34063a hb led driver, cm6807



    Leave a Reply