August 6th, 2009
What are those three circuit for this purpose? There are General Purpose Ignition Switch Generator (for 20 kV, 20kA pulse) Circuitry, Thyristor Switch and Step Up Pulse Transformer Circuit (specific spike production on the a-c line), and Relay Type Switch with Resonant Circuit. Each of those three circuit are described in detailed description with such schematic diagram of the surge generator type. [...]
August 17th, 2012
The TDA5140A device is a bipolar integrated circuit which commonly used to draw 3-phase brushless DC motors in full-wave mode. This Brushless DC motor drive device is sensorless using the back-EMF sensing technique to sense the rotor position. This device used to be apply in applications such as VCR, laser beam printer, fax machine, blower, automotive. [...]
August 15th, 2012
A: Apply momentary ground to reset hours to zero.
B: When using the MTH6 with inductive loads, we recommend installing a suppression diode across all coils.
C: Terminals 4 and 8 may be grounded on negative ground power supply.
D: Alternator must be equipped with a tach terminal (auxiliary AC terminal).
E: Connecting full battery potential to terminal 9 can cause damage
to the switchgage. Shutdown circuit is rated for 300 mA continuous. Circuit grounds out at set point. [...]
August 14th, 2012
The laser driver circuit diagram shows the schematic of an IC-NZN application, an all-purpose laser driver circuit. It operates from 3.3 to 5.5 V and can drive N, M, and P-type laser diodes with or without monitor diode. The latest generation of all-purpose integrated laser driver solutions supports switching frequencies up to 155 MHz and laser currents up to 300 mA. [...]
August 10th, 2012
The phase shift oscillator works in such a way that if the amplitude of the inverting amplifier is not high enough the system will continually attenuate the signal until the amplitude is zero, it was therefore decided to change the amplification power of the inverting amplifier. [...]
August 8th, 2012
The schematic diagram shows NCP1034 demo board which is designed with many options. You can see such a linear regulator which has function for powering the IC with Zener diode, compensation circuit of second or third type, ceramic or electrolytic output capcitors and various input capacity. [...]